« Previous Entry | MAIN | Next Entry »
September 05, 2004
Well...
Titan is good quality...if you can get them
"bushed" the cost isn't too bad. The
needle bearing set is very expensive for
sure but it's quite a beefy, well put
together set-up. Very rigid.
I got a bushed set from Bill Perry at Rivergate on my current Cooper S
spec. Rivergate-built 1293.
Not sure of the brand name however
they were very reasonably
priced and I've no complaints.
The 1.5's are
of course, "nosier". They run an extra
3 thou over stock rocker clearances.
(www.Rivergate5speed.com)
Cap'n. Bob
'60 :{)
PilotRob@... 11150
Posted on September 5, 2004 12:26 AM
Posted to category(s) Carburetor
| Cylinder Head
| Engine (internal)
| Miscellaneous
| Restoration
| Specifications
| Tuning
