« Previous Entry | MAIN | Next Entry »

June 15, 2003


I had my MC sleeved with brass but there seems to be a problem the
pistons don't move freely. I know that the bores need to be opened up
a little. How do you know when enough material has been removed? I
planned on using 600 grit wrapped around a dowel with tape to make up
the difference. Also there are two small holes into each bore from
the top are both supposed to be open? Thanks for your help, the 65
Sprite is getting very close to being reborn.
Martyn

"snook32907" < meastwood1@... > 22677

Posted on June 15, 2003 09:27 PM
Posted to category(s) Engine (internal) | Exterior | Miscellaneous | Technical Info

Email this entry to:

   Your email address:

Message (optional):