« Previous Entry | MAIN | Next Entry »
July 12, 2003
Cut off outer sill and decided to replace inner sill rather than put plates over the little bits of rust on it. Have heard of jacking point reinforcers can any one describe these and when and how to fit them? If not available commercially I was going to just weld a plate around the jacking tube hole in the inner sill to make it a bit thicker here and spread the load.
Thanks
Terry
"terry.isherwood" < terry.isherwood@... > 23339
Posted on July 12, 2003 08:09 PM
Posted to category(s) Body | Restoration
