« Previous Entry | MAIN | Next Entry »
November 18, 2003
I am in the process of rebuilding my 1500 engine. I am looking for
some feedback on what is the best way to Pin aq thrust washer in
place. I have read some papers that talk about using three 1/8"
roll pins, I have not seen any feedback on how well this works.
My second question is related and it involves machining down the rear
bearing housing to accept a second thrust washer that is held in
place using three brass screws. The idea sounds good but what is the
long term feedback.
(see
http://www.geocities.com/MotorCity/Speedway/1080/thrustwasherinstall.h
tml for more information)
Thanks
"vince_gulley" < vince_gulley@... > 26703
Posted on November 18, 2003 03:01 AM
Posted to category(s) Engine (external) | Engine (internal) | Exterior | Lubrication System | Miscellaneous
