« Previous Entry | MAIN | Next Entry »
November 12, 2003
2 other options to remove the lock-nut:
- Dremel with a cut-off wheel: cut the nut partially on two sides, then use
a chissel (used
this technique often by now with 100% success without damaging any
threads!)
- Weld a long bar to the nut
I prefer the first option. It will cost you 1 or 2 cut-off wheels, but will
be succesfull. Even if you accidently cut a bit to deep, it probably makes
so little damage to the threads you won't have to replace the damaged part.
Good luck,
Eeg.
Eeg.Oberije@... 26599
Posted on November 12, 2003 09:47 AM
Posted to category(s) Exterior | Miscellaneous | Wheels
