« Previous Entry | MAIN | Next Entry »
May 29, 2004
How do you get that #@#**# key back into the fulcrum pin? I tighted
the bolt backed it up until I could feel the key slip into the slot.
It locks everything it place nicely, but the thread part doesn't show
up at the other end so I can put the nut ont.
I've grease the key, frozen the key,lubed it, no luck. And when you
hammer the sh*t out of it, it pens, and distorts.
Is it OK to grind it down a little bit to make it fit?
thanks,
Bruce
"redrider417" < bgberlin@... > 32368
Posted on May 29, 2004 03:17 AM
Posted to category(s) Engine (external) | Exterior | Lubrication System | Miscellaneous | Suspension & Steering
