« Previous Entry | MAIN | Next Entry »
June 24, 2004
They are a real challenge! I have removed serveral this way: Soak
(and I mean SOAK) the bolts with penetrating oil for a day or two.
Put the nut back on the bolt and turn until the end of the bolt and
the nut are even. Get a BIG hammer and hit the end of the bolt hard!
After a few hits it will begin to move. You will have to use a punch
to finish the job. The rear ones are harder because you can't get a
good swing with the hammer. Just keep working on them. Although I
have never used it, I guess propane torch would loosen things up
also, but the burning rubber is really stinky!
Hope this helps,
John
of
I'd
"mg_john2" < salemlibrary@... > 32747
Posted on June 24, 2004 08:55 PM
Posted to category(s) Engine (external) | Gauges | Lubrication System | Miscellaneous
