« Previous Entry | MAIN | Next Entry »
July 17, 2003
Just make a tow bar. It is simple and cost next to nothing.
First a piece of 1" angle iron cut to about 3.5'. then drill two holes in it
at the distance part that the front bumper studs are. Also hole must be big
enought for the bumper studs to fit through.
Then get a 4" "U" chanel about 4' long and weld them together to make a "T".
Add acouple to small straps from the ends of the angle to the "u" neer the
far end. Then drill holes in the far end of the "U" chanel and bolt on a Std.
Hitch..
Then take off the front bumper use the same nuts and washers to attached your
tow bar to the car and away you go. Works Great!
_______CAR__________
l l
AAAAAAAAAAAAAA
s U s
s U s
s U s
s U s
s U s
sUs
U
H
H
frenchww@... 23517
Posted on July 17, 2003 10:05 AM
Posted to category(s) Cylinder Head | Engine (external) | Engine (internal) | Exterior | Miscellaneous
