« Previous Entry | MAIN | Next Entry »
November 18, 2003
Somebody has probably already told you this already, but just in case, the 'o' ring (round section seal) goes at the botom,(at the bottom of the swivel pin/king pin) and the flat seal goes at the bottom of the dust excluder tube, as a seal to keep dirt and water out. If you need diagrams, I can scan them in out of my original BMC parts list. One of these days I ought to scan the lot and put it on a site somewhere.
R
"Roger Stinson" < rogerstinson@... > 26708
Posted on November 18, 2003 11:55 AM
Posted to category(s) Cooling System | Engine (internal) | Lubrication System
