« Previous Entry | MAIN | Next Entry »
February 19, 2004
From: Guy Weller [mailto: Guy.Weller@... ]
Sent: Thursday, February 19, 2004 3:51 PM
To: midgetsprite@yahoogroups.com
Subject: Re: [midgetsprite] Hood rubbers/seals
No, because what is happening is that the clamps pull the header rail down
onto the top of the screen at the wrong angle, - sort of tilted backwards.
One symptom of this is the tendancy for the little lug of the clamp to try
and jump to the wrong (front) side of the narrow upstand on the rear edge
of the screen top rail.
Adjusting the wear out of the pivot points means that the header rail is
presented to the screen top rail at the correct angle for the clamps to
work.
I am not argueing this as the only cause, but I do think it is a factor.
Guy
"Duncan Sinclair" < duncan@... > 29908
Posted on February 19, 2004 05:14 PM
Posted to category(s) Body | Exhaust System | Exterior | Ignition System | Lubrication System
