« Previous Entry | MAIN | Next Entry »
March 27, 2004
Hi,
I am in the middle of recovering my seats so I took a photo of one of
the seat bottoms. The holes are about 1 1/2 inches in diameter and
are bored to about 3/4 of an inch from the top.
I posted the photo in Jim Curtice's photos...
I already did one of the seat bottoms but didn't bore holes. Now
that I've read these posts, I'll probably have a go with the second
one. If it goes well I may rework the other seat.
Jim Curtice
"Jim Curtice" < curtice3@... > 31021
Posted on March 27, 2004 08:34 AM
Posted to category(s) Engine (internal) | Exterior | Interior
