« Previous Entry | MAIN | Next Entry »
April 29, 2004
Groupies -
Has anyone found a good way to strip the factory rust proofing from the bottom of a Midget? My 75 has rustproofing about as hard as concrete, I'll been finishing the top side and interior soon and was hoping to remove most of the under coating by hand someway to speed the striping process. Would a hand propane torch and a puddy knife work, or will I set it on fire? I have a small blaster and know it would take way to long to blast through all that sludge.
Talk at ya'll Later
Rick Bender
"Rick Bender" < rick.jnb@... > 31744
Posted on April 29, 2004 06:16 AM
Posted to category(s) Exterior | Interior | Restoration | Tuning
