« Previous Entry | MAIN | Next Entry »
July 17, 2003
sorry, the only measurements I have seen are for use with original dealer
body checking gauge sets, so you're out of luck unless you happen to have
one of those hanging around!
You could try marking your own datum points on the centre-line of the car
(start by making diagonal lines from fixed points left and right to
accurately find the centre) then measure where the shock absorber mounting
holes come relative to this centre.
One other thing, have you checked the top trunnions to make sure they're
the same each side?
Regards
David
"David Jacobs" < davidj@... > 23522
Posted on July 17, 2003 08:27 PM
Posted to category(s) Body | Exterior | Gauges | Ignition System | Suspension & Steering
