« Previous Entry | MAIN | Next Entry »
July 13, 2003
mid page at
http://www.teglerizer.com/midgetstuff/interior2.htm
you can see the line of holes where the dash bolts to the
sheet metal.
(pictures of dashboard not installed mid page)
You should be able to 'approximate' where to start
looking for the bolts by comparing stuff lower down.
also...at the bottom of the dash, you have a few 'straps' that
are the lower mounts for the dash. Remove the screws
on those mounts and you can 'bend' the dash out about 2"
to more easily access the rear of the gauges.
Paul Tegler
ptegler@...
www.teglerizer.com
"ptegler@cablespeed" < ptegler@... > 23364
Posted on July 13, 2003 01:26 PM
Posted to category(s) Engine (external) | Gauges | Interior | Miscellaneous | Technical Info
