« Previous Entry | MAIN | Next Entry »
July 12, 2003
Hi
I think I might be to late put my two pennyworth in. I have just done the
very same job on my Mk1 Midget and it is exactly the same.The rear end was
fixed to a point behind the trim with a self tapping screw.The frount and
had a small bracket that fixed around the trim and bolted to one of the nuts
that are attached to the padding on top of the dash.As far as the trim
around the door space is concerned this is fixed by little clips with barbs
on them that clip on to the door surround opening, in theory 10 each side
but I used 16.I opened the trim a little bit to ease it on and then inch by
inch clamped it up again when in place around the door with a pair of
molegrips with the jaws wrapped in a cloth to keep the new trim clean. Mine
now looks great,no kinks or bulges.
Cheers Gordon Denson
"Gordon Denson" < gordon@... > 23336
Posted on July 12, 2003 05:13 PM
Posted to category(s) Body | Cylinder Head | Drive Train | Exterior | Interior | Miscellaneous | Suspension & Steering
