« Previous Entry | MAIN | Next Entry »
March 10, 2004
How is it done? I have read the method in the Haynes, and I am not certain
any of the 4 bolts on each side will survive being taken off! or even if
they will come undone at all. tried one and it sheared immediately, another
is just turning and it looks nearly impossible to get a spanner of the upper
side of it on the inner two bolts. The inner two wishbone pins are loose
which is to be expected after years of being covered with oil and grease.
4.5 inch bolts threaded all the way seem a bit thin on the ground! and
threaded rod does not seem to be an ideal solution give the nut on either
end can turn!
Stewart
General Reality Failure : Reboot Universe
"Ford Prefect" < f.prefect@... > 30664
Posted on March 10, 2004 08:03 PM
Posted to category(s) Electrical System | Engine (external) | Engine (internal) | Gauges | Lubrication System | Miscellaneous | Technical Info
