« Previous Entry | MAIN | Next Entry »
July 01, 2004
I'm upgrading my early model .875" bore master cylinder to the later
model with the .75" bore and I'm getting it brass sleeved by Joe at
Sierra Specialty Auto too, but I have a problem. The plastic internal
bits from the .75" MC came out in pieces=85 and I don't see
replacements in the VB catalog.
Is there an alternate source for these plastic bits, and are they
specific to either the clutch or brake side=85 or are both bore
assemblies the same?
Any suggestions?
Cheers & TIA,
-Drew
"Drew Griffith" < drewzer@... > 32837
Posted on July 1, 2004 04:36 PM
Posted to category(s) Braking System | Engine (internal) | Technical Info | Transmission
