« Previous Entry | MAIN | Next Entry »
July 29, 2004
Jens
I spoke to Burlen this morning as I mentioned and they were very
helpful. I've ordered up two spindle kits, two rubber washers and
two new AN needles from them.
For interest and reference for others going down this route in the
future the cost of drilling out the spindle holes in the carb body
and putting in inserts for the new spindle is about =A320 GBP +
VAT.
The new spindle kit (comes with butterfly screws and gaskets)
was =A36.87 GBP + VAT and the AN needle =A36.33 + VAT.
The moral behind this is to avoid buying these kind of parts from
Moss because they are a lot more expensive, get them direct
from Burlen who have the remanufacturing rights for SU parts
and Moss probably just buy them in from them.
Http://www.burlen.co.uk
Nigel
"amukdigiphoto" < amukdigiphoto@... > 33181
Posted on July 29, 2004 11:47 AM
Posted to category(s) Body | Carburetor | Drive Train | Engine (internal) | International | Lubrication System | Miscellaneous | Tuning | US States | Wheels
