« Previous Entry | MAIN | Next Entry »
February 04, 2005
Frequently, people jack and adjust the alignment to the doors fit perfectly,
then carefully weld a piece of pipe or angle iron from the front of the door
opening to the rear, just tack it in, on both sides and then form an "X"
from the front of one door opening to the rear of the other door opening and
visa versa. Would not hurt to tack these two pieces together where the "X"
crosses also. Then before doing anything else, re measure and or fit the
doors in place to double check a perfect fit. With out the sills, the frame
is like Jello.
Good Luck
Bob in San Diego
"Robert D. Gardner" < rdgard@... > 35963
Posted on February 4, 2005 03:32 PM
Posted to category(s) Body | Exhaust System | Exterior | Intake System | Miscellaneous | Suspension & Steering
