« Previous Entry | MAIN | Next Entry »
March 13, 2005
I got my resleeved master and clutch slave cylinders for my bugeye back from
Whitepost and installed them. When I started to bleed the brakes more fluid
came out around the brake line attachment point than came out of the bleeder
at the rear brake. I didn't replace all the brake lines and would really
prefer not to do that. When I installed the lines I just screwed them into the
master cylinder (after cleaning them first with clean brake fluid and drying
them). Is there something else that I should have done? Any ideas on what
is causing and how to correct the leak?
Thanks
Bob
rlirwn@... 36321
Posted on March 13, 2005 07:07 PM
Posted to category(s) Braking System | Cooling System | Engine (internal) | Lubrication System | Miscellaneous | Transmission
