« Previous Entry | MAIN | Next Entry »
May 12, 2005
Rob :
My headers (puttin in a V8) are custom made, actually a set of Chevy
small block pick-up headers cut up with new Buick flanges, custom collectors
with mandrel bent tubes. They are actually turning out better than I
expected.
My next question is the front valance structure, I basically need to remove
everything but the lower front exterior valance sheet metal, does anyone
have photos of any Midgets that this has been done to? I'll need to build a
new tube structure to hold the new radiator, etc. I don't really want to use
hood pins, so I was hoping to find an alternative method of holding the hood
down, anyone have ideas?
Later
Rick Bender
"Rick Bender" < rick.jnb@... > 37054
Posted on May 12, 2005 07:09 AM
Posted to category(s) Body | Cooling System | Engine (external) | Exhaust System | Exterior | Technical Info
