« Previous Entry | MAIN | Next Entry »
September 21, 2003
Jim,
Sounds way too tight, but this isn't a "seat of the pants' thing.
You need a dial gauge and a magnet stand to check end float. You
need to exert force in both directions and see what the dial gauge
reads. From memory, I think .003 is the upper limit, but check the
specs first.It 's possible for them to be too tight. Are you using
standard or overside thrust washers? They are marked for size on the
backside.
Gerard
"gerardchateau" < pixelsmith@... > 25439
Posted on September 21, 2003 08:00 PM
Posted to category(s) Carburetor | Gauges | Interior | Miscellaneous | Restoration | Specifications
