« Previous Entry | MAIN | Next Entry »
February 20, 2004
I am fitting new seels to my dual master
cylinder and are wondering which way the end
bit in the clutch cylinder goes.
At the very far end of the return spring is a
metal cup and inside this cup there should go
a smaller rubber cup (shaped as a cup).
The one i took out had turned around on its
side thats why i am wondering which way to
fit the new one.
Is the bottom of the cup facing forward (ie towards
the firewall) or backward, it looks like it will fit either way.
Jens
Jens P. Maudal jens.maudal@...
Greetings from "BottomsUp Brewery"
Drammen - Norway
Work: +47 32833566, mobile: +47 90540409
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
Visit my humble RIMS and homebrew page:
http://home.c2i.net/bottomsup/index.htm
Norbrygg bryggeside: http://www.norbrygg.com
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
"jens maudal" < jens.maudal@... > 29920
Posted on February 20, 2004 08:13 AM
Posted to category(s) Body | Engine (internal) | Suspension & Steering | Technical Info | Transmission | Wheels
