« Previous Entry | MAIN | Next Entry »
March 10, 2004
Nigel, pardon me for ignorence but where
do those grease drenched felt washer for the
handbrake mechanism go, is it inside the handle
support?
Jens
Bill
Strangely enough, I had planned on doing work on my rear axle
yesterday, mainly to install the brake pipes but I had a few other
jobs to do as well, such as re-installing the circlip that 'pinged'
off!
I had already bought two of the original type circlips for this and
also bought some circlip pliers for the job. I have to say it was
about a 5 second job to install those circlips - went on sweet as
a nut - no problems, so much so I took the other 'e' clip off and
installed the other 'original' circlip.
I wish everything else had gone as well as this - installing those
felt washers drenched in grease into the handbrake mechanism
was like the trial of job!
Nigel
"jens maudal" < jens.maudal@... > 30655
Posted on March 10, 2004 03:26 PM
Posted to category(s) Braking System | Cylinder Head | Drive Train | Exhaust System | Exterior | Intake System | Interior | Lubrication System | Miscellaneous
