« Previous Entry | MAIN | Next Entry »
July 22, 2004
Don,
You can lower the front buy installing non RB front springs and if that dosen't lower it enough put in spacers between the spring pan and the A-arm. Spacers can be made from some thick (1/4") wall pipe/tubing and longer mounting bolts. Cutting down the front springs would be my last resort. For the rear a spacer block between the axle and spring. The spacer would be a block the width of the spring with a locating stud on it's top to fit the upper spring plate and a hole in the bottom to clear/locate it on the bolt that holds the spring together. New longer U bolts would be required.
Biff Jones
'59 Bugeye 'Kermit'
'61 AH Sprite 'Ole Gray' in the "Healey Book"
'71 Midget 'Freebie"
http://sprites2.homestead.com/
"Biff" < biffjones@... > 33094
Posted on July 22, 2004 10:02 AM
Posted to category(s) Body | Cylinder Head | Drive Train | Engine (external) | Engine (internal) | Exhaust System | Exterior | Intake System | Miscellaneous | Suspension & Steering | Technical Info | Wheels
